SEIWA K421 Aluminum License Plate Bracket, Black, Adjustable Angle, Offset Number Plate Bracket for Car Exterior

●This license plate bracket is made of lightweight aluminum with a black finish. ●It allows you to tilt your license plate forward by approximately 5°. ●It allows you to move your license plate up by up to approximately 50mm. (Height adjustment: Approximately 20-50mm)

[Caution] ●This bracket is designed to be installed in the standard mounting position of your license plate. It may not be possible to install it on vehicles where the license plate is attached using the original base or bracket, or it may be unstable or leave a noticeable gap between the plate and the vehicle. ●This product is for front license plates only. Do not use it on rear license plates of kei cars. ●The surface of this product may discolor if exposed to hot water above 80°C, such as in a steam car wash. ●If you lose your original license plate mounting bolts or the bolts included with this product, you can use commercially available bolts (sizes: M6-12mm). All Seiwa license plate frames comply with the new standards. From SEIWA, a leading manufacturer of automotive accessories with over 50 years of experience in the domestic automotive accessories market.

[Lightweight, rust-resistant aluminum license plate bracket] This license plate bracket is made of lightweight aluminum with a black finish. [Approximately 5° tilt, for front use only] The license plate can be tilted 5° and moved up by up to 50mm. (Height adjustment: Approximately 20-50mm) [Accessories] License plate bracket itself, two bolts with washers (built-in type), and two nuts. All SEIWA license plate frames comply with the new standards.