Solid State Relay Module 60A 3 To 32VDC Input 60A 480VAC Output DC To AC Solid State Relay

Feature: 1. LED Indicator: This DC to AC solid state relay utilizes an LED indicator to provide a very visible and clear indication of the operating status. 2. Transistor Output: This 60A solid state voltage regulator uses a transistor output with low on state voltage drop and fast switching speed. 3. Excellent PBT Material: This solid state relay module is made of excellent PBT material, which is anti erosion and anti vibration, reliable working. 4. Safe And Reliable: The input and output circuits of this solid state relay are optically isolated from each other, which is not easy to be crosstalked and is safe and reliable. 5. Wide Application: This 60A solid state relay has a wide range of applications, mainly used in industrial automation, weak power isolation control, strong power isolation control and a variety of high power DC electrical equipment. Specification: Item Type: Solid State Relay Material: PBT, Red Copper Model: VSR860DA48Z Input: 332VDC Output: 60A, 480VAC Load Current Range: 0.1 to 60Arms Inrush Current: 10mSec (Maximum)

200percent Load Voltage Range: 60VDC1200VDC On State Voltage Drop: less than 0.54.6 Off State Voltage: 60V, 80V, 250V, 400V, 600V, 2900V, 1200V Over Voltage Protection: Transient Protection Voltage: 80V, 180V, 470V, 1000V Switching Characteristics: Mos or IGBT Solid State Non Contact Switching Characteristics Dielectric Strength, Input to Output (50, 60 Hz): 2500Vrms Dielectric Strength, Input or Output to Base (50, 60 Hz): 2500Vrms Minimum Insulation Resistance (at 500 VDC): 10 degrees Ohm Safety Factor for Load Current: 2.5 to 3 Times for Resistive Loads, 3 to 6 Times for Inductive Loads Ambient Operating Temperature Range: 3080 degrees C Storage Ambient Temperature Range: 30100 degrees C Humidity in Accordance with IEC60068278: 95percent . LED Input Status Indicator: Red. Package List: 1 x Solid State Relay Note: 1. The heat generated by the relay should be dissipated through the base plate, make sure that the base plate of the relay is in close contact with the heat sink and is securely mounted, and that the contact surfaces are coated with heat?conducting gaskets or heat conducting silicone grease.2. Relay terminals should be securely wired, loose wiring will to abnormal heating and damage to the product. the recommended installation torsion for M4 terminals is (1.2?2.0) N?m, and the recommended installation torsion for M5 terminals is (2?3) N?m.3. If the product operates in a high ambient temperature, please refer to the temperature curve for derating.Safety Warning.1. The sides and bottom plate of the product may become hot during use, so please touch the product after it has cooled down.2. Before installing or using the product, please make sure to disconnect all power sources.3. Please check all connections before turning on the power.LED Indicator: This DC to AC solid state relay utilizes an LED indicator to provide a very visible and clear indication of the operating status. Transistor Output: This 60A solid state voltage regulator uses a transistor output with low on state voltage drop and fast switching speed. Excellent PBT Material: This solid state relay module is made of excellent PBT material, which is anti erosion and anti vibration, reliable working. Safe And Reliable: The input and output circuits of this solid state relay are optically isolated from each other, which is not easy to be crosstalked and is safe and reliable. Wide Application: This 60A solid state relay has a wide range of applications, mainly used in industrial automation, weak power isolation control, strong power isolation control and a variety of high power DC electrical equipment.